Step-by-Step
SMCSetting up the Distributed SystemConfiguring the Projects in DistributionChanging the Distribution Connection Type
SMCSetting up the Distributed SystemConfiguring the Projects in DistributionChanging the Distribution Connection TypeChanging the Distribution Connection Type
This procedure describes how to modify the distribution Connection type of the distribution partner project that you have added either using Automatic or Manual mode.
- ▷
- At least one project (started or stopped) is available under the Projects folder and you have enabled the distribution for this project.
- 1.
- In the SMC tree, select Projects > [project].
- 2.
- Depending on whether project is Started or Stopped, do one of the following:
.
.- 3.
- Open the Distribution Participants expander.
- 4.
- Select an entry for the distribution partner project.
- 5.
- Open the Distribution Connection expander and perform the following steps:
- -
- Modify the default distribution Connection type Bi-directional (
) to unidirectional (
) such that the Originator project (Local System) can see () the Partner project.
- -
- Modify the default distribution Connection type Bi-directional () to unidirectional (
) such that the Originator project (Local System) will be seen () from the Partner project.
NOTE: When you click Sync, the Connection type is synced on the Partner System.
.- ⇨
- A distribution partner project entry is updated and saved with the updated Connection type.
- ⇨
- If the selected project is a running project and the Connection type changes from to any other Connection type or changes to from any other Connection type, a message displays asking you to restart the project.
- 7.
- Click OK.
, and then clicking 
.Next Step
Related Topics